To view our IMO Report, please click here

Remarks: Matt Soft Leather Mural Seaming Instructions: Panels marked to be applied in order they are cut with an overlap fit of 10mm vinyl to vinyl. Cut edges are marked to trimmed at site by installer, on or off site.

Block lengths may vary, therefore, they should be trimmed on site during installation.
Eye-due to installer

Clear Coatings: No clear transparent coatings is permitted on this material, as it will result in an undesirable glossy finish.

Matching Panel Seams: Seams should be thoroughly rolled from side to side when first applied while adhesive is still wet to insure maximum contact with adhesive. Every 5-6 lin. meters, remove with the seam width of top decorative layer only, discard the bottom layer, align remaining decorative layer seam and continue application. This overlap and cut seam eliminates pattern matching.

Inside/Outside Corners: Use seam roller to push film into contact with bottom layer. Hand working with fingers to mold fit when deemed necessary. Alternate cutting methods for tight corners: 1) After vinyl is wrapped around inside corner and installed, cut through both layers in a "V" or birds-beak rip-proof cut., 2) On outside corners use Aero tool drill cut or feather-edge and wrap on subsequent surface.

Installation: Installation temperatures between +10º and +28º Celsius. Surfaces must be clean, smooth and dry.

Strataflex with matching muraspec wallcoverings

@endsection