– Not recommended for use in direct sunlight conditions.

Product Specifications

Length/roll : 22.86 metres

Width : 137,2 cm

Weight: 180 g/m²

Pattern: Glitter.

Packaging: Roll size and package quantity may vary.

Opacity: Odour free.

Cleaning: Occasional dusting with a dry cloth is recommended.

Price: Price on application

.

Technical Specification:

This product complies with the French VOC legislation A+.

Product Behavior on Surface ISO 11998/85.

Adhesive strength:
Initial bond test for 24 hours 300c is> 14 Newton
Indirect bond test for 24 hours 30°C is> 14 Newton
Peeling strength 90 degree peel (initial bond) above 70 N/25mm above

Technical Characteristics:

1. This product is self-adhesive, requires no additional adhesive for rib installation however adhesion is enhanced on aging.

2. Sufficient supply of rolls with uniform color and printing is possible.

3. We use water-based paint systems that are free from environmentally harmful substances.

4. Recommended storage temperature: 5-40°C

Installation:

In order to apply the Strataflex – Metallic |Bias Line decorative film, follow these simple instructions:

1. Clean the surface where the film will be applied. Make sure it is free from dust, grease, oils, or any other contaminants.

2. Measure and cut the film according to the size of the area you want to cover. Leave a few extra centimeters on each side to ensure a perfect fit.

3. Carefully peel off the backing material from the film, starting from one end.

4. Place the exposed adhesive side of the film onto the surface, slowly rolling it out and pressing it down as you go.

5. Use a squeegee or flat tool to remove any air bubbles or wrinkles from the film. Work from the center out towards the edges.

6. For best results, it is recommended to leave the film to cure for at least 24 hours before applying any pressure or cleaning.

7. To clean the film, simply use a cloth or sponge with warm water and a mild soap solution. Avoid using any harsh cleaners or chemicals.

8. To remove the film, slowly peel it off starting from one end. If any adhesive residue remains on the surface, it can be easily removed with a mild solvent or adhesive remover.

Note: For best results, it is recommended to always test the film on a small and inconspicuous area before applying it to the entire surface.