How to Use Muraspec Strataflex

1. Ensure surface is clean, dry, and dust free.

2. If necessary, repair any imperfections to ensure a smooth and even surface.

3. Measure and cut the Strataflex to the desired length, leaving an extra 2-3cm for trimming.

4. Pre-fit the Strataflex to the surface without removing the backing paper to ensure correct placement.

5. Once satisfied with the placement, remove a portion of the backing paper and smooth the Strataflex onto the surface, using a wallpaper brush or soft cloth.

6. Slowly peel the backing paper off while continuing to smooth the Strataflex onto the surface, making sure there are no wrinkles or air bubbles.

7. Continue this process, slowly peeling the backing paper off and smoothing the Strataflex onto the surface until the entire surface is covered.

8. Use a straight edge and sharp blade to trim any excess Strataflex from the edges.

9. Press a wallpaper brush or soft cloth along the edges to ensure a strong adhesion.

10. For best results, let the Strataflex cure for 24 hours before exposing it to any moisture or heavy wear and tear.

11. To clean, use a mild detergent and warm water. Do not use abrasive cleaners or harsh chemicals.

12. Enjoy your newly transformed surface!