– Custom colours/gradients are available on request. Small Minimum Order Quantities apply.

– For samples, please contact marine@muraspec.com, Tel: +44 (0)207 731 7300.

– For Pricing, please contact our Customer Services team: marine@muraspec.com, Tel: +44 (0)207 731 7300.

Product Specifications

Width: 130cm

Thickness: Approximately 1.5mm (may vary – maximum 2.0mm)

Backing: Printed mono plastic film

Weight: 250gm/m²

Fire Rating: EN13501-1 – Euro Class B slot XY

Water-resistant and meets IMO A.653 FTP Code Part 5. It is IMO MED certified, and carries the WheelMark.

Lightfastness: Min 6 (ISO 105-B02)

Antimicrobial Properties: Yes ISO 22196:2011

Chemical Resistance: Good (EN423)

To EN 423, Resistance to chemicals. Urine and Sweat resistant to EN ISO 105-E04.

Tensile strength: EN 53354 1508 warp 1474 weft inN/50mm

Cold Crack: EN 495-5 – (-23°C-) remains flexible

After 5 hours at -23°C there is no visible effects on the appearance of the product. Modulus of elasticity in tension, is calculated and is not more than 30% different to the room temperature value.

Note: The test is temperature related only and has no relevance to degree of flexibility testing.

Use classification: 22-Heavy Residential and 33-Heavy Commercial use

Suitability: Walls, Ceilings and general use.
Not suitable as a flooring material.
This product is recommended for dry internal surfaces. If covered by film, the application will remain below 60°C until failure of the film and herewith remain below 60°C.

Chemical resistance: To EN 423 Resistant to top branded cleaning chemicals (The below stringent cleaners do not effect floorcovering.) Isopropyl Alcohol (70% concentration) USP Ammonia solution, 1.25% solution of dishwashing detergent 10-20 drops/min 250ml, isopropyl alcohol 15cm patch 30sec, 0.99 formic acid 10cm patch 30sec and a 25% potassium chloride

Installation Method: Suitable on solid surfaces, m^2 Self Adhesive film suitable for Application by Pressure Sensitive Glue onto Wall Surfaces installed Apply the adhesive to fully coat back of the film and ensure an even spread full surface Adhesive. Surface does not dry extremely hard, always remain slightly plastic.

Full instructions and precautions on how to apply the product are detailed on the accompanying technical data sheet and must be strictly adhered to. Please email marine@muraspec.com to receive the technical data sheet, explanatory video, test report and fire certification.

Please Note: There are a variety of substrates, methods and adhesives that may affect the application and longevity of the pro